[200q20v] Re: climate control errors 08 and 15

[Fred Munro]

Hi Sean;

The connector is located under the plastic plenum cover. The temp flap
regulating motor has an integral wiring harness  about 12" long and it plugs
into a connector on a main harness near the firewall.  These codes can also
be caused by a dirty or bad potentiometer on the motor.

Fred

----- Original Message -----
From: "Sean Ford" <audi_92_100cs at yahoo.com>
To: "Fred Munro" <munrof at isys.ca>; <hah at srv.net>; <quattro at audifans.com>
Cc: <200q20v at audifans.com>
Sent: Friday, August 04, 2000 9:47 PM
Subject: Re: climate control errors 08 and 15


> --- Fred Munro <munrof at isys.ca> wrote:
> > Hi Henry;
> >
> > Check the connector to the temp flap regulator motor. This was the
> > source of
> > these codes on my '91 200q. Some Stabilant 22A fixed it up.
>
> Fred,
> where would that be? I just checked and I have the same damned codes!
> 8.7 and 15.1. Amazing.
>
>
> =====
> Sean Ford
> audi_92_100CS at yahoo.com
> http://www.geocities.com/seanford.geo
> '92 Audi 100CS 5-spd non-q
> '00 Triumph Daytona 955i
> '89 Suzuki Katana 600
>
> __________________________________________________
> Do You Yahoo!?
> Kick off your party with Yahoo! Invites.
> http://invites.yahoo.com/
>