[200q20v] Re: Susension bushings

[C1J1Miller at aol.com]

In a message dated 4/22/01 7:05:08 AM Eastern Daylight Time, 
dpulvino at agraus.com writes:

> I replaced subframe bushings, inner control arm and all sway bar bushings, 
> outer ball joint ends, strut bearings, and the struts.

How did you replace the outer ball joint ends?  I assume you mean the ones on 
the lower control arm?  Those are not replaceable, I've been told, without 
replacing the whole lower control arm.

Perhaps you mean tie rod ends?
Chris