[200q20v] Wheel Bearing
C1J1Miller at aol.com
C1J1Miller at aol.com
Thu Feb 1 12:55:24 EST 2001
Go to Scott Mockry's page under tips/suspension...
Don't try to hammer the new one in; there's a tool (rental also) that can install the bearing on-the-car; otherwise you're likely pulling the strut to bring it to a machine shop.
Chris
In a message dated Thu, 1 Feb 2001 12:46:16 PM Eastern Standard Time, "John Clarke" <EdwardClarke at mail.gov.nf.ca> writes:
<< Hi there
I posted a message last week at the 20v section with no response--will try again here as it gets much more traffic. I need to replace a front wheel bearing on my 90q 20v, I have one ordered from Blau and would like to know if anyone has any tips on the installation. Can I loosen the ball joint with a pickle fork without destroying the boot? Is it too much aggravation to try to drive out the old bearing and install the new by hand (ie. the old hammer and wood method) or should I just take the housing to a garage and get it done with a press? I also need a new exhaust and was wondering what the consensus is on the main aftermarket exhausts available (BB TriFlow, Scorpion and Stebro)?
Thanks
_______________________________________________
200q20v mailing list
200q20v at audifans.com
http://www.audifans.com/mailman/listinfo/200q20v
>>
More information about the 200q20v
mailing list