[200q20v] Tranny Replacement

[Kneale Brownson]

I'd think the system is mounted on flexible points so that SOME movement 
can occur.  If you can only feel movement and not see it readily, I'd guess 
that there still is life in them thar mounts.



At 10:00 AM 02/20/2001 -0500, Phil Rose wrote:

>At 9:14 PM -0700 2/19/01, Mike Miller wrote:
>>The way I checked my tranny mounts is as follows:
>>
>>Lift throttle in any gear - if the shifter moves, the rear mounts are 
>>likely bad. After I replaced mine, the was NO movement of the shofter on 
>>lifting the throttle.
>>
>>mike miller
>
>I have tried to check for shifter movement. While I thought I could _feel_ 
>some slight movement, it's hard to say it's enough  to actually be seen. 
>Is _any_ amount of movement "too much" (i.e., enough to warrant mount 
>replacement)?   I'll check again--I suppose there could be as much as 1/8" 
>movement under some conditions. That doesn't seem very bad, to me, but...?
>
>Phil
>--
>
>Phil Rose
>Rochester, NY
>mailto:pjrose at frontiernet.net
>_______________________________________________
>200q20v mailing list
>200q20v at audifans.com
>http://www.audifans.com/mailman/listinfo/200q20v
>
>