[200q20v] Bar readings with no boost

Forhan, Thomas Thomas.Forhan at mail.house.gov
Wed Jan 31 09:49:20 EST 2001


When I reported a max reading of 2.5bar on my factory digital gauge with my
unknown source chip, Rich Andrews asked about the readouts with the engine
off and at idle. This morning I found:

1) ignition on, and not running: 1.3 - so it is indicating .3 bar high,
correct?
2) idle- cold: .8 bar, warmed up .9 bar.

Comments, thoughts?

Thanks, Tom F.

> -----Original Message-----
> From: Rich Andrews [mailto:r at cm183316-a.ftwrth1.tx.home.com]
> Sent: Monday, January 29, 2001 8:54 PM
> To: Forhan, Thomas
> Subject: Re: [200q20v] Current Thoughts on Spark Plug Wires
> 
> 
> With the ignition on and the car not running what is the readout?
> What is the readout at idle?
> 
> rich
> 
> Forhan, Thomas wrote:
> 
> > I'm thinking abuot replacing my spark plug wires and am 
> wondering what
> > others might have been doing. 
> > 
> > Any experience with the set that Blau sells?
> > 
> > Magnecor has sets in 7mm, 8mm, and 8.5 mm. What is best?
> > 
> > Other options?
> > 
> > This 130K miles car has an unknown chip installed by a 
> prior owner, clearly
> > running over 250hp, though I am sure the 2.5 bar on the 
> factory indicator is
> > bogus. 
> > 
> > Thanks
> > 
> > Tom F.
> > _______________________________________________
> > 200q20v mailing list
> > 200q20v at audifans.com
> > http://www.audifans.com/mailman/listinfo/200q20v
> 
> 
> -- 
> Rich Andrews  Sr. Unix Admin.
> http://www.mslite.com
> 



More information about the 200q20v mailing list