[200q20v] Distributor alignment - from radiator project

[Reid, Les C.]

Thanks Chris,
That may be what I have, I know its close. I will look where the rotor
exactly lies relative to #1.  

I was going by a mark on the Aluminum cover under the rotor (the cover
rotates with the rotor).  I had assumed this mark and the mark on the dist
body should line up.  
Maybe that is an incorrect assumption?
I have till this weekend to work it out.

Les

-----Original Message-----
From: C1J1Miller at aol.com [mailto:C1J1Miller at aol.com]
Sent: Monday, June 04, 2001 12:16 PM
To: Les.Reid at centrilift.com
Cc: 200q20v at audifans.com
Subject: Re: [200q20v] Distributor alignment - from radiator project


I've got the distributor alignment tool around somewhere...

As I recall, it is a simple plastic piece that aligns the rotor with the
body of the dist., and holds it in place while you install it; the rotor
looks like it should be centered over the little hash mark on the side of
the dist.

I'd assume you want the #1 at TDC, and rotor pointing towards the #1 wire.
Is this what you've got?
Chris