update, [200q20v] Dist. Cap/Rotor?

[Les Reid]

Just a follow-up:
Drove the car with the modified rotor.
Worked OK, So far so good.

Les

--- Les Reid <mrlesok at yahoo.com> wrote:
> Chris,
> I had the same problem at the supliers (at least Rod
> TPC knew what I was asking about).  Just last week I
> modified the wider rotor by removing material from
> both sides  of the tip (with Dremel tool) to match
> the
> org rotor width.  
> I have it back on the car but will not get a chance
> to
> see if I have any problems until the weekend.
> It was really pretty easy,  I lightly sanded the
> edge
> afterwards to remove the burrs.    
> 
> 
> Les
> 
> --- "Hemberger, Chris" <CHemberger at stanadyne.com>
> wrote:
> > Does anybody know definitively if the 20V/3B
> > distributor cap & rotor are
> > interchangeable with the standard, 10valve
> engine's?
> >  Checked the Bosch
> > web-parts listing but don't see it - local
> > Euro-parts house says yes & I was
> > hoping to get today for R&R tonight.  Thanks in
> > advance...
> > 
> > Chris Hemberger
> > 91 200Q Avant
> > 
> > _______________________________________________
> > 200q20v mailing list
> > 200q20v at audifans.com
> > http://www.audifans.com/mailman/listinfo/200q20v
> 
> 
> __________________________________________________
> Do You Yahoo!?
> Get personalized email addresses from Yahoo! Mail -
> only $35 
> a year!  http://personal.mail.yahoo.com/
> _______________________________________________
> 200q20v mailing list
> 200q20v at audifans.com
> http://www.audifans.com/mailman/listinfo/200q20v


__________________________________________________
Do You Yahoo!?
Get personalized email addresses from Yahoo! Mail - only $35 
a year!  http://personal.mail.yahoo.com/