[200q20v] Re:Strut Brace Details
Bernie Benz
b.m.benz at prodigy.net
Thu Mar 8 16:32:50 EST 2001
George, It sounds like you're coming around, half way there anyway.
> From: George Sidman <sidman at montereynet.net>
> Date: Thu, 08 Mar 2001 12:51:56 -0800
> To: Phil Rose <pjrose at frontiernet.net>
> Cc: Bernie Benz <b.m.benz at prodigy.net>, 200q20V mailing list
> <200q20v at audifans.com>
> Subject: [200q20v] Re:Strut Brace Details
>
> Upon further measurement last night, there is indeed some
> additional clearance, at least in my car, for the strut
> brace to be mounted higher, but not quite enough to
> completely clear the plenum forward flange. I placed a 40
> inch length of half inch EMT across the flange, with the
> weatherstrip removed. I then spotted it with thin dollops of
> putty, which were sprinkled with blue chalk, and shut the
> bonnet. It closed with no apparent interference. Upon
> opening it up I found chalk marks across the hood and liner.
> The clearances are too tight, and the possibility of
> contact, etc. too great. So, once again, Bernie is right
> (siiiigh) and some notching will be required.
George, I'd check your measurements too. What suprises me is the sudden
interest in the Benz Brace. Where have you guys been since I first
disclosed the design to you in Nov '99?
>
> I still intend to use something other than EMT, and will
> probably float the rod ends off the washer a bit. I am now
> investigating what it would cost to send the assembly out to
> have it gilded............
Why not just slop body undercoating on it to damp the resonant vibrations?
> --
> George Sidman, President
> Nousoft, Inc. - Monterey Network Center
> www.nousoft.com - www.montereynet.net
> sidman at montereynet.net
> 9701 Blue Larkspur Lane
> Monterey, CA 93940
> 831 657-1510
> _______________________________________________
> 200q20v mailing list
> 200q20v at audifans.com
> http://www.audifans.com/mailman/listinfo/200q20v
More information about the 200q20v
mailing list