[200q20v] loosening a rounded nut

Brett Dikeman brett at brettd.dsl.speakeasy.net
Thu Mar 15 21:31:00 EST 2001


On Thu, 15 Mar 2001, omllenado wrote:

> I was replacing my alternator this afternoon, got the alternator out, in, but when it comes to loosening the bolt on the bar on  the A/C side - boom
> it's so hard to unloosen that the nuts were rounded. I can't tension the belt without loosening this side. 
> any suggestions on how to get it off?, I was thinking of having the bolt melted and replace it but i dont have the equipment.

Nah, cut it off.  Moto-tools are god's mechanical gift to humanity.

They make a cutoff attachment that can hold light, heavy, and super duty
cutoff disk wheels.  Don't skimp on which duty rating you pick...too light
a disk will disintegrate unless used very carefully, and if the metal is
too hard, the disc will simply go poof(or crack; eye protection is a
-MUST- with any griding tool.)

The great thing about the mototool is that it can be used to grind very
finely, so you could, if you wanted, slot the bolt on both sides, and hit
it with a hammer or something, once you started to hit the threads on the
bolt(at which point, there wouldn't be much bolt left.)

Several slots might give you more of a purchase on the bolt with say, vise
grips.

The heavy vibration and heat from the cutting disc might loosen
up the bolt a little...

Brett




More information about the 200q20v mailing list