[200q20v] RE: [s-cars] Inlet Air Temp code

[TM]

Derek, Bernard-
Thanks much for the continued help. I have not disconnected the ECU and
measured resistance there. I will do that this week- funny thing is, after
I played with the connection, no more check engine lights. Go figure.

I'm going to clear the codes and let it be- the connector was crimped and
soldered onto the harness so as to connect the new style sensor. It's quite
possible that I'm seeing an intermittent connection at the splice, I have
to check that.

If I continue to get codes, I'll pull the ECU and measure resistances at
the pinout. I have to fix my seat memory, install boost gauge and a/f meter,
replace O2 sensor before I do much more of anything else, along w/ fixing
the antenna amp hookup to my stereo, properly securing my amp to the rear
seat bulkead (req. removal of rear seat- PITA), etc. The list goes on....

Taka