200q20v gearbox 016?

[Martin Pajak]

Mihnea,

The US 200 q 20v uses 016 with 4:11 ratio.
Check code on the tranny against ETKA which says 4:11 gears ar in AOB, AUP,
AUN, AOC, ADZ, ADY.
To see if it swaps you need to check if the locker will slip in place of
torsen.
Splines on input shaft to the front diff will be deciding factors.
>From ETKA look like there is a different part number for the pinion shaft
even though both are 4:11 one with AP and the other with AT code letters.
This does not mean the splines would be different, however no guarantee.
Why not just use torsen?

BTW you have to be careful of gear ratios.  They are designed for taller
tires.
Might throw your drivability out window with N/A motor.

Hope this helps.

Cheers
Martin Pajak

http://www.quattro.ca

1983 Audi Ur-quattro (269,000 km) Canadian spec. winter car
1985 Audi Ur-quattro (146,000 km) Euro spec. import ;o)




> -----Original Message-----
> From: quattro-admin at audifans.com [mailto:quattro-admin at audifans.com]On
> Behalf Of Mihnea Cotet
> Sent: April 18, 2002 14:32
> To: quattro at audifans.com; 200q20v at audifans.com
> Subject: 200q20v gearbox 016?
>
>
> Fellow listers,
>
> I need help on this one, is a 200q20v gearbox a 016 gearbox type? If yes,
> would it be possible to swap the Tor$en center diff for a good old locker
> from a 4kq to use in my '85 coupe quattro? What's the 200q20v's final
> drive? Is it a 4.11 or a 3.89? How hard would the swap be?
>
> Thanks for any input,
>
> Regards from Belgium,
>
>
> Mihnea
>
>