Intake Air Temp Sensor

Peter Schulz peschulz at cisco.com
Wed May 29 17:00:14 EDT 2002


According to Scott Mockry, the connection is spot welded.
http://www.sjmautotechnik.com/20vairt.html
;^)

"It is a good idea to pull back the rubber boot around the wiring
connection and check for frayed or broken wires. These wires are spot
welded or soldered on by the factory. Small crimp on terminals can be used,
but spot welding or soldering makes for a better connection. "

-Peter


At 11:51 AM 5/29/2002 -0700, you wrote:
>I cleaned it again yesterday, letting it soak in gasoline for about ten
>minutes before coming in with the brush.  So far no check engine light.
>
>Good idea about disconnecting, I just wish it was easier to attach and
>reattach those solders.  30 watts from Radio Shack just doesn't cut it!
>
>I think it goes someting like this; "Don't know what ya got, till it's
>gone..."
>
>dp

Peter Schulz
1990 CQ
1991 200 20v TQW indigo mica
1991 200 20v TQW titanium grey
Chelmsford, MA USA
peschulz at cisco.com




More information about the 200q20v mailing list