crank case breather - sheesh

[DAK]

Hmm. I wondered about this after reading Scott JM's site. For only
$4.27, I build something to connect the crank case to the part of the
hose that wasn't totally trashed (just at the back edge of the engine
block). I did the heat shield bit and hope it will hold for a few short
trips. I just didn't want things open to the atmosphere.
I wonder how the oil likes having those little bits of rubber dropping
into it! When I took the one end of the hose off, all kinds of rubber
bits fell out. I imagine some of this was going into the crank case.
I feel kind of stupid. I looked at the family album again and found the
20v part! Just needed that AF on the end! Rats!
$85 is kind of a bummer, but I guess it could be worse! I'll be on the
phone to Didi on Monday.
Thanks to those who pointed out my blunder!
David

Audi Sport wrote:

>[ Converted text/html to text/plain ]
>If I was you I would not waste my time buidling some new hose untill you get
>the right part. The car will run just fine without it. It's only the section
>that connects to the crankcase that fell apart, correct?
>
>
>Dan B.
>
>------------------------------------------------------------------------------
>Send and receive Hotmail on your mobile device: Click Here[1]
>
>===References:===
>  1. http://g.msn.com/1HM1ENUS/c152??PI=44364
>
>_______________________________________________
>200q20v mailing list
>200q20v at audifans.com
>http://www.audifans.com/mailman/listinfo/200q20v
>