Shift linkage refurbishment

[Ingo D. Rautenberg]

Thanks, Mike, but this has happened since before I replaced the trans mounts
(which were done at the same time as the clutch....hmmm.

Ingo

----- Original Message -----
From: "Mike Miller" <mikemilr at blackfoot.net>
To: "Ingo D. Rautenberg" <ingo at waratap.com>
Cc: <200q20v at audifans.com>
Sent: Friday, September 20, 2002 12:52 PM
Subject: Re: Shift linkage refurbishment


>
> ----- Original Message -----
> From: "Ingo D. Rautenberg" <ingo at waratap.com>
>
>
>
> > As mentioned before, I have the same symptom as Phil, except that in my
> Lago
> > Blue 200q20v sedan (is it the color?) it is only in the forward-throw
> > gears -- I imagine 1,3 & 5; but honestly, I don't keep her in 1st long
> > enough to tell.
> >
> > I, too, can eliminate the noise by pulling up on the shift knob. This is
> NOT
> > the throwout bearing (BTDT).
> >
> > My shifter is also on the sloppy side.
> >
> > -Ingo
>
> This sounds like it could be the rear tranny mounts.If the shift lever
moves
> a lot front to back when lifting/applying throttle, I would check them
out.
>
> mike miller
> helmville mt
>
> _______________________________________________
> 200q20v mailing list
> 200q20v at audifans.com
> http://www.audifans.com/mailman/listinfo/200q20v
>


---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.386 / Virus Database: 218 - Release Date: 9/9/2002