Causes for overheat indicator? Preferred 02?

[Chuck Pierce]

Mike
 I just replaced my MTFS to get rid of the over temp symbol. ( I also
got some boost back 1.4 vs 1.7 ) Pull the connector off and take it for
a drive, the problem should go away if the MTFS is the problem.

Chuck
91 200tq Avant ......Very slowly getting sorted out.

Mike Del Tergo wrote:

> It appears that even thinking about dropping my aux rad from the Avant is
> causing problems.  Yesterday I got the "low coolant/overheat"
> indicator symbol on the dash readout.  The water temp guage said below
> 1/2,
> the oil temp was below 2nd has mark, and the rad fan had not cycled
> and the
> overflow tank is not particularly pressurized.  The coolant level sensor
> checks out fine, so I am thinking Multi Function Temp Sender or
> regular temp
> sensor in back of head.  If I read Bentley correctly, the head sensor
> flows
> to the MFTS then to the gauge idiot lights?  Any ideas? Also any BTDT for
> Bosch generic 3 wire 02 for the car, PN 13913?
> Thx
> Mike
>
>
>
>
>
> _________________________________________________________________
> Tired of spam? Get advanced junk mail protection with MSN 8.
> http://join.msn.com/?page=features/junkmail
>
> _______________________________________________
> 200q20v mailing list
> 200q20v at audifans.com
> http://www.audifans.com/mailman/listinfo/200q20v
>