Blinking out the CODES...

[Alan Cordeiro]

In my case it required removal of the Instrument Cluster. The bulb location
was just empty. Since I was in there fixing the center message display
I replaced a couple of other bulbs, and "added" the CE lamp back.

Any small twelve volt indictor will work. Most LEDs tend to be polarized,
so a simple "grain-o'wheat" 12 volt lamp is a no-brainer to hook up.

Alan
----- Original Message -----
From: <DasWolfen at aol.com>
To: <200q20v at audifans.com>
Sent: Sunday, August 03, 2003 8:49 AM
Subject: Re: Blinking out the CODES...


> --
> [ Picked text/plain from multipart/alternative ]
>  Just curious.......why not make the C/E lamp operational? The wiring is
> already installed in the car and its as simple as locating the two halves
of a
> plug and connecting them. (assuming someone hasnt swiped the C/E bulb to
replace
> another position elsewhere in the I/C)
> _______________________________________________
> 200q20v mailing list
> 200q20v at audifans.com
> http://www.audifans.com/mailman/listinfo/200q20v
>