RS2 ?'s

Mihnea Cotet mik at info.fundp.ac.be
Tue Dec 16 16:27:40 EST 2003


Ok Brett.

Chances are it simply won't run properly. I have already tested a regular 
2.5 Bar chipset in an RS2-spec 3B engined car (less the injectors) and it 
just won't go right, mixture was way too rich and timing was simply too 
much retarded to get proper power out of the setup, so, well, yes, you'll 
have more than a stock engine with the III+ but waaaaaaaaay less than you 
could have with a proper ECU remap done on the fly, wether on the dyno or 
whilst driving the car.

HTH,

mihnea

At 16:22 16/12/2003 -0500, Brett Dikeman wrote:
>At 8:23 PM +0000 12/16/03, Mihnea Cotet wrote:
>
>>WRT efficiency (for Brett), it is not all a matter of boost levels or 
>>intake air temperatures but rather a matter of air flow supplied by the 
>>turbo. Let's say we want to run a stock turbo with 2.3 Bar absolute boost 
>>at 6k RPM in order to get close to 300 HP, just because 2 Bar makes 
>>between 270 and 280, the result, even with extra intercooler sprayers or 
>>whatever to keep the intake temps low, will only be overspinning the 
>>turbo and possibly ripping the shaft apart.
>
>The original question was "what will a III+ w/RS2 manifold and RS2 turbo 
>get me".
>
>My reply was that you'll get more power because the RS2, being more 
>efficient at higher boost, will produce a cooler charge under similar 
>circumstances.
>
>Brett
>--
>----
>"They that give up essential liberty to obtain temporary
>safety deserve neither liberty nor safety." - Ben Franklin
>http://www.users.cloud9.net/~brett/



More information about the 200q20v mailing list