Radiators, now BTDT

Derek Pulvino dbpulvino at hotmail.com
Fri Jul 25 10:36:20 EDT 2003


Peter,

All of the mounts were slightly distorted, but the rubber didn't show any
sign of breakdown.  But along with that "slightly distorted," I am curious
if a new mount out of the box is going to be shaped like a cylinder.  IE
sides at 90-degrees from the bottom all the way around...or in other words,
the bolts right on top of each other on both sides.

Derek P

>
>
>Derek:
>
>Good to have another data point.
>
>BOTH my wagon's main radiators appear to be "sagging" towards the driver's
>side fender, with the resulting premature failure of the upper right
>(driver's fender rubber mount )  When I replaced the radiator on the Blue
>Wagon with the Nissen's, I did notice that the lower mount (on the driver's
>side) was deformed.  Unfortunately I did not order replacements so I tried
>to make up for some of the deformation by using some washers as spaces and
>not completely tightening the mount ( to make up for the difference in
>height.)
>
>So, as in most things, YMMV...
>
>-Peter
>
>
>Peter Schulz
>1990 CQ (awaiting S2 3b engine transplant)
>1991 200 20v TQW indigo mica
>1991 200 20v TQW titanium grey
>Chelmsford, MA USA
>peschulz at cisco.com
>

_________________________________________________________________
STOP MORE SPAM with the new MSN 8 and get 2 months FREE*
http://join.msn.com/?page=features/junkmail




More information about the 200q20v mailing list