K24 turbo fitting

[Brandon Rogers]

That sounds like that modified K26 turbo by Innovative that was discussed on
the S-Car list a while back.  I'd be _real_ curious to hear feedback on it
once it's up and running.

Brandon

----- Original Message ----- 
From: "Ben Swann" <benswann at comcast.net>
To: <200q20V at audifans.com>
Cc: "Ben Swann" <benswann at comcast.net>
Sent: Thursday, March 18, 2004 1:17 PM
Subject: K24 turbo fitting


I'm installing a hybrid turbo on a 200Q20V for someone.  Turbo is modified
K26 to look like "k25" - don't ask me for details, I don't know, only that
the intake impeller  was clipped, or something to that effect.

My question pertains to a fitting that was on the k24 but not on the modded
k26.  This fitting is some type of pressure/vacuum port on the front/snail
part of the turbo.  On the modified turbo, there is a boss that could be
tapped if necessary.

This port on the k24 went to a four way tee or "cross".  The top of the
cross is a solenoid.  The bottom goes to the fitting in question.  One arm
of the cross goes to the lower wastegate port and the other arm goes to the
backside of the turbo intake hose.

What is this fitting for and how critical to use?   Unless there is some
reason, I am just going to block off the bottom of the "cross" and hope
it'll be just fine without.

Ben

_______________________________________________
200q20v mailing list
200q20v at audifans.com
http://www.audifans.com/mailman/listinfo/200q20v