PS PUmp rebuild?

[alan cordeiro]

Peter,

Definitely all the o-rings under the "X" caps. and the main large
o-ring inside just below the pressure relief valve. I have yet to
see the main shaft seal go, but if you have it in your kit, and access
to a good puller and a press,  you might as well change that one too.

The biggest problem I found was to open some of those caps
with the 'X' on them. Lubricate the o-rings so they don't
"squirrel" when you tighten up the caps again.

Alan

----- Original Message ----- 
From: <PeterBergin at aol.com>
To: <200q20v at audifans.com>
Sent: Sunday, May 08, 2005 6:59 PM
Subject: PS PUmp rebuild?


> HI guys, I have been nursing a small leak in my PS pump for about 20k with
> Lucas stop leak.  The leak is from underneath the pump, not the hoses or
pulley
> seal.  I have an O-ring/seal kit from Blau and two cans of Green Gold, but
no
> instructions.
>
> I somewhat remember ancient posts on leaky O-rings from under the caps of
the
> pump.  One of them appears to be the leak (which is now massive).  So I
plan
> on doing this tomorrow.  Any one care to walk me through it?  Do I need to
do
> a full pump rebuild or just the O-rings under the caps?
>
> Thanks,
> Pete 91 Avant
> _______________________________________________
> 200q20v mailing list http://www.audifans.com/mailman/listinfo/200q20v