ProConTen-frustration

[patrick.anderson1 at comcast.net]

Check the hard heater pipe that runs underneath the water manifold. There is a bracket that one of the tranny bolts runs through. It really likes to get right in between the bell housing and tranny. It caused me that same 1/2" gap during reassembly. 

Patrick

-------------- Original message -------------- 
From: Kneale Brownson <kneale at coslink.net> 

> I got the retaining bracket for the cables off my transmission, but that 
> didn't free up the cables to allow me to put them over the top of the 
> structure on the transmission that sits in front of the cables. I imagine 
> that if I had removed the bracket before disengaging the transmission from 
> the engine, there would be just enough slack to allow them to slide over 
> that structure. And now I can't seem to slip the tranny back against the 
> engine to see if that's the case. I can get to about where I have a 1/2" 
> gap between the cases, but can't close it. So what's keeping the 
> transmission from sliding back next to the engine? I've tried jacking it 
> up more, lowering, pushing side to side, etc. 
> _______________________________________________ 
> 200q20v mailing list http://www.audifans.com/mailman/listinfo/200q20v