Front wheel bearing

[Peter Schulz]

John:

Had the same happen to me,,,,unfortunately think that its coming from 
the outer CV joint
;-(

-peter

At 04:33 PM 2/24/2006, John S. Lagnese wrote:
>It didn't dribble after everything was apart.
>Thanks,
>John
>----- Original Message -----
>From: "Chuck Pierce" <cpcycle at earthlink.net>
>To: "John S. Lagnese" <jlagnese at massed.net>; "200 list"
><200q20v at audifans.com>
>Sent: Friday, February 24, 2006 2:17 PM
>Subject: Re: Front wheel bearing
>
>
> > When you pull the axle bolt out, the dribble coming out the hole is from
> > the grease in the CV joint.
> > Unless a bunch comes out it should not be a problem. If it continues put
> > the bolt back in after you pull the axle
> > out of the hub. The grease from the CV joint and the axle bearing are not
> > shared.
> >
> > Chuck Pierce
> > 91 200tq Avant
> > John S. Lagnese wrote:
> >
> >>Hi,
> >>I'm changing my right front wheel bearing on my 91 200 Quattro Turbo 20V.
> >>There was some type of oil oozing out when I took out the axle bolt and
> >>then inside the hub. Is this just the wheel bearing losing its grease? I
> >>didn't see any other source. I've never seen this before, as you could
> >>probably guess.
> >>Thanks,
> >>John
> >>_______________________________________________
> >>200q20v mailing list http://www.audifans.com/mailman/listinfo/200q20v
> >>
> >>
> >
>
>_______________________________________________
>200q20v mailing list    http://www.audifans.com/mailman/listinfo/200q20v

-Peter Schulz
Chelmsford Ma, USA

1991 200 20v Q Avant Titan Grey
1991 200 20v Q Avant Indigo Mica
1991 90 20v Q Red
1990 CQ silver (awaiting S2 engine transplant)
1990 CQ red ( to part or not)