Clutch slave "removal"

[Kneale Brownson]

Thanks, Patrick.  Just the information I needed.


At 06:29 PM 7/27/2006 +0000, patrick.anderson1 at comcast.net wrote: 
>
> Kneale, 
>  
> The slave just comes straight out the back. Your's sounds a little sticky so
> just give it a good yank. If you aren't replacing it just tie it up out of
> the way or remove the line and set it aside. 
>  
> I believe the connector you are looking for is located on the top side of the
> tranny near the bell housing/block mating point. I seem to recall tracing the
> wires from the sensors on the passenger side of the tranny and following them
> up to where I finally found the connector. I'd actually started to remove the
> sensors on the tranny before figuring out I just had to unplug the connector
> and could leave the sensors/wires attached to the tranny.