Removel of glove box?

[Kneale Brownson]

Bentley says glovebox assemblies may vary.  Mine comes out with loosening
of two Alan head screws visible at the top inside of the box near the back.
 They're 4mm.  A standard 4mm Alan wrench can be manipulated to slip into
the screw heads, but cutting a quarter inch off the short arm allows for
easier insertion.  If I remember correctly, you just loosen them a couple
turns and you can slide the box sideways and out.  




At 04:20 PM 6/2/2006 -0400, Peter Schulz wrote:
>Peter:
>My recollection is at least four small philips head screws, two on 
>the left and two on the right side of the opened glove box.  The only 
>way to get at them was to buy a small bit socket wrench and use a 
>philips bit -no way to get a standard philips screwdriver in there....
>
>-Peter
>
>At 03:54 PM 6/2/2006, PeterBergin at aol.com wrote:
>>Was trying to work on my intermittent dash vents (AC on only problem),  Found
>>the re circulation flap is always closed, even in "LO" temp setting.   Spring
>>was good and box had a bunch of leaves in it.  However it will not  open when
>>I turn the AC temp way down and that's usually when I loose my dash  vents.
>>
>>Got frustrated trying to remove the glove box and found the illustration in
>>the Bentley useless.
>>