Front wheel bearing

[Chuck Pierce]

A couple of months ago when I started to rebuild my front end
there where no rebuilt axles available ( not even from SJM ), so I had 
the learning experience
of doing the C/V joints.  Messy but not hard. Just need extra hands to 
take the
outer C/V joint apart. The outer is a automotive rubic's cube, but fun.

Chuck  Pierce


Mike Miller wrote:

>Isnt it easier and cheaper to just buy the 1/2 shaft for about $125? New CV 
>joints and bearings, already assembled.
>
>mike
>
>----- Original Message ----- 
>From: "John S. Lagnese" <jlagnese at massed.net>
>To: "PETER CATALANO" <kruzio2003 at yahoo.com>; <200q20v at audifans.com>
>Sent: Wednesday, March 22, 2006 7:59 PM
>Subject: Re: Front wheel bearing
>
>
>  
>
>>When I just did my 91 TQ20V I used the Harbor Freight hub kit.
>>John
>>----- Original Message ----- 
>>From: "PETER CATALANO" <kruzio2003 at yahoo.com>
>>To: <200q20v at audifans.com>
>>Sent: Wednesday, March 22, 2006 4:01 PM
>>Subject: Front wheel bearing
>>
>>
>>    
>>
>>>I am replacing the outer cv joint on 1990 200 qt 10v. I want to do the
>>>wheel bearing as well. can you tell me what puller and press you used to
>>>R/R the front wheel bearings.
>>>
>>> it seems i need to pull the hub out of the bearing and then press the
>>>bearing  out.
>>>
>>> peter
>>>
>>>
>>>---------------------------------
>>>Yahoo! Messenger with Voice. PC-to-Phone calls for ridiculously low 
>>>rates.
>>>_______________________________________________
>>>200q20v mailing list http://www.audifans.com/mailman/listinfo/200q20v
>>>
>>>      
>>>
>>_______________________________________________
>>200q20v mailing list http://www.audifans.com/mailman/listinfo/200q20v 
>>    
>>
>
>_______________________________________________
>200q20v mailing list	 http://www.audifans.com/mailman/listinfo/200q20v
>
>  
>