Clutch tools
Kneale Brownson
kneale at coslink.net
Thu May 25 16:26:23 EDT 2006
What special tooling do I need to perform a clutch replacement? My
new-to-me Avant needs a new throwout bearing, so I'm figuring I should make
use of the group-buy clutch and rear crankshaft seal I've had sitting here
for a couple years. I have a fender-bridge type of engine support. I have
tools to disengage the axles and center driveshaft. I have a hoist. Is
there an alignment tool I need for reinstallation? Anything else I should
do at the same time? Car came with papers indicating a new clutch MC and
slave were installed just a few thousand miles ago.
More information about the 200q20v
mailing list