Ignition switch failure

[nick at beol.net]

I did this fix on my '90 200tqa.  I reused my existing lock cylinder and  
key, no change needed.  When you have the new assembly in hand (that has  
the good tang on it) look for a tiny drive pin that holds the whole  
together. Remove this pin and swap in your existing lock cylinder.
Once again if Audi would sell this 50 cent or $5 part instead of the whole  
assembly...
I have a picture if anyone needs to see it.
Nick


> underneath the dash!)
> Got the switch out this morning... Low and behold the tang is broken off  
> the
> end of the tumbler assy.
> Looked in the archives, only found a few posts for the 200 20v..
> Suggestions, BTDT?
> Eric
> _______________________________________________
> 200q20v mailing list	 http://www.audifans.com/mailman/listinfo/200q20v
>



-- 
Using Opera's revolutionary e-mail client: http://www.opera.com/mail/