Strut Braces, again!

[Andrew Schlueter]

Ya know, the v8's too have those strut tower braces. It is a t44 and
might be better suited for the 200's.

The tower supports look the same as the urs4/6, but have a round bar as
the brace.

Andrew W. Schlueter
'90 V8 MQuattro
'90 Jetta VR6TTQ
'87 4000cs
www.hausofdub.com

-----Original Message-----
From: 200q20v-bounces at audifans.com [mailto:200q20v-bounces at audifans.com]
On Behalf Of Eric Huppert
Sent: Tuesday, April 24, 2007 1:07 PM
To: 200q20v
Subject: Strut Braces, again!

EK,

Tower brackets are off of UR s4/S6. Not sure on the bar, but it does
look
somewhat similar to the s6 bar

This type tower brace isn't going to correct weak towers (and
corresponding
camber issues), you need a "jack-bolt" on the bar that will spread
towers
back as needed. At one point in time Chuck Pierce (lister) had made a
batch
of the center bars, but don't believe he's made anymore. I had expressed
some interest (no funds at the time though), as had some others, but
guess
there wasn't enough takers to warrant making any more.

I'm probably going to get the tower brackets used and have a bar made.
Guess
I need to do it soon as new tires just replaced the snows and my toe
setting
is off a little bit due to previously replacing outer sway bar bushings
and
one control arm.

cheers, Eric

_______________________________________________
200q20v mailing list
http://www.audifans.com/mailman/listinfo/200q20v