Request for Advice - Totalled '91 200 20V TQ
PeterBergin at aol.com
PeterBergin at aol.com
Mon Jan 15 18:21:15 EST 2007
In a message dated 1/14/2007 11:36:49 P.M. Central Standard Time,
b.benz at charter.net writes:
Pete, comment below.
> From: PeterBergin at aol.com
> Date: Sun, 14 Jan 2007 20:56:21 EST
> To: mikemilr at blackfoot.net
> Cc: 200q20v at audifans.com
> Subject: Re: Request for Advice - Totaled '91 200 20V TQ
>
> Hi mike, a bunch of little stuff on my list.
>
> 1. A fully working IC cluster, I have tried several times to repair my
> check display with no luck.
Did mine by adding small telephone wires on the surface of ground and power
traces across the thin PC section between existing solder points on each
trace. solved.
Had it out 3 times, first time cleaned with circuit board cleaner(lasted 6
months), second time re flowed solder joints, still no auto check display,
third time yesterday while replacing Ac aspirator, added some trace wires, still
no improvement. 3 strikes, it out.
> 2. Drivers side black sport seat in good shape with working seat heater.
Working seat heaters, you¹re kidding! Repaired mine twice, forget it! The
old horse deserves a stable, garage it.
Park outdoors in Minnesota nfen (no further explanation needed)
> 3. Seat heater dash switch.
Easily repaired, take it apart and fix it.
Not if I can get a working one cheep or free!
> 4. Avant lower chrome and rubber side window trim.
> 5. Brass distributor gear, (will do the group buy if it happens).
Sorry that you missed mine.
Me too!
> 6. Audi oval emblem that goes on the frond fender trim.
> 7. Recircleation flap vacuum servo, mount broke off of flap.
ABS pipe cement?
Temporary fixed with 4 zip ties. T-E-M-P-O-R-A-R-Y
> 8. Glove box light assembly.
Early causality, who cares?
I do!
> 9. Non leaking windshield washer fluid tank, mine leaks when filled
> more that 1/2 way.
What¹s wrong with half way full?
Live in Minnesota, always runs out when I need it most!, May try and fix.
> 10. Working steering column switch for the cruise control.
If you remove the switch, you¹ll find a broken ground wire in the lever
bundle. Replace with a high flex wire, such as solder de wick stuff.
BTDT, Think it might be the connectors in the sliding switch.
Thanks, Pete
More information about the 200q20v
mailing list