Alignment specs

[Bernie Benz]

Saw slots through the board, parallel with the length of the board, ¼  
“ from the outer edges, 2 on each end of the board, of a depth equal  
to the width of a measuring tape, and wide enough to accept the end  
fitting of the tape, flat wise. Thus a universal fixture, can be used  
in any orientation.

Bernie

On May 22, 2007, at 1:17 PM, Eugene Kanter wrote:

> Yes, that is correct. What do you mean by "saw slots"?
>
> On Tue, 2007-05-22 at 13:08 -0700, Bernie Benz wrote:
>> Eugene,
>>
>> Do you understand the basics of total toe measurement? If so, I am
>> doing the same thing but referencing to the outside of the tires’
>> sidewall plane 5” off the ground with the boards, instead of
>> measuring to the inside of the tire or wheel. Just a simpler and more
>> accurate way of accomplishing the same thing. You want a pic of a 2’
>> board with saw slots on the ends?
>>
>> Bernie
>>