200 20V Running issues/ Code

[Claus Vegener]

Have you pulled the fuse to the ECU (for 10 sec)
This ree-sets fault codes so you can try again.
Claus
----- Original Message ----- 
From: "Tony Hoffman" <auditony at gmail.com>
To: <200q20v at audifans.com>
Sent: Tuesday, September 11, 2007 1:41 PM
Subject: 200 20V Running issues/ Code


> Ok guys, I've run across a stumper.
> 
> I'm working on a friends 200 20V Avant. He bought it with a running
> problem, namely whenever on boost it would start to miss/buck. He had
> a friend of his pull the line off the wastegate, and it was "good" for
> about a month. Now, it runs pretty poorly all the time, to the point
> of dying on occasion.
> 
> So, I checked the cam timing, spot on. Checked for boost leaks, can't
> find any. The code that comes up is 2224. Here is the description,
> courtesy of SJM autotechnic:  "Maximum Charge Pressure Exceeded,
> Intake air leak after turbocharger, ECU Vacuum/pressure line has leak
> between intake manifold
> Waste gate or pressure hose, Waste Gate Solenoid/hose problem, ECU
> pressure sensor malfunction
> Symptom: Misfire during wide open throttle, boost pressure too high"
> 
> The symptom is exactly what I'm experiencing. I pulled the line going
> to the ECU, and I have good vacuum and boost present there. What are
> the chances of the internal boost sensor in the ECU going bad? Anybody
> have any other ideas?
> 
> Stumped in Oklahoma,
> Tony Hoffman
> _______________________________________________
> 200q20v mailing list http://www.audifans.com/mailman/listinfo/200q20v