Head Gasket

[Claus Vegener]

Just use the now recommended standard 3B/AAN/S6 steel gasket.
No problems with 500+Hp and 600 Nm / 2Bar boost
Claus
----- Original Message ----- 
From: "Ben Swann" <benswann at verizon.net>
To: <quattro at audifans.com>; "'200q20V mailing list'" <200q20v at audifans.com>; 
<s-car-list at audifans.com>
Cc: "'Ben Swann'" <benswann at verizon.net>
Sent: Monday, June 23, 2008 4:25 PM
Subject: Head Gasket


>
> I'd like to get some recommendations on which headgasket I ought to be 
> using for a built
> 3B block - 2.3l using JE pistons, Pauter ConRods and stock compression 
> AFAIK when using
> 3B head.  The 3B head is being swapped for AAN head that will be port 
> matched and
> polished a bit.  Mostly stock otherwise, but would like to be able to take 
> some serious
> power and using ARP studs to clamp down head.
>
> Is there any particular headgasket I ought to be using?  I don't want to 
> drop or raise
> the compression.
>
> Ben
>
> _______________________________________________
> 200q20v mailing list http://www.audifans.com/mailman/listinfo/200q20v
>