91 200 trans seal
Bernie Benz
b.benz at charter.net
Sun Mar 2 10:56:03 PST 2008
Any brand of engine oil stop leak will do, CD-2, Eagle, Turkey, etc.
Buy 2 cans, one in the engine, ½ in the tranny, ½ in the rear diff.
Gunk and hose down the engine bay and full underside such that you
can monitor leak status. I have never had to replace a rotary shaft
seal in any car, some over 300K.
Bernie
On Mar 2, 2008, at 10:30 AM, Nathan Winters wrote:
> I need to do the same, any recommendations? I've never used the
> stuff before...
> Could you list a few snake oil products you've tried?
> The best luck I ever had was on my 90 Corrado, it had a leaky power
> steering something, I put in a bottle of Eagle (at least it had an
> eagle on the gold bottle) and it never leaked again.
>
> Thanks,
>
> Nathan
>
> ----- Original Message ----
> From: Bernie Benz <b.benz at charter.net>
> To: John S. Lagnese <jlagnese at massed.net>
> Cc: 200q20V mailing list <200q20v at audifans.com>
> Sent: Sunday, March 2, 2008 1:19:13 PM
> Subject: Re: 91 200 trans seal
>
> Before you go to the trouble and expense of changing a seal, add ½
> can of engine snake oil to the tranny oil and drive for 1K miles.
>
> Bernie
>
>
> On Feb 27, 2008, at 5:10 PM, John S. Lagnese wrote:
>
>> Is it uncommon for this seal to go? Is there any other potential
>> points to
>> check for a leak on that side of the tranny? Its a drip every
>> couple of
>> seconds when the gear oil level is high. Otherwise it drips while I'm
>> running.
>> John
>> ----- Original Message -----
>> From: "Austin Calise" <stincalise at yahoo.com>
>> To: <200q20v at audifans.com>
>> Sent: Wednesday, February 27, 2008 12:33 AM
>> Subject: 91 200 trans seal
>>
>>
>>> Not spring loaded. Ok if your certain it's
>>> the axle flange seal........To remove the axle flange
>>> run a CV bolt in with a chisel behind the flange
>>> and it will pop out.(may have do this twice 180
>>> of the first bolt.) To remove the seal a pry bar
>>> or screw driver will work just be careful not to mar
>>> the machined surfaces. I've heard of using Curil T
>>> sealant to make sure cam style seals don't leak.
>>> http://www.pelicanparts.com/catalog/shopcart/9144/
>>> POR_9144_ENGmis_pg1.htm
>>> HTH's Austin
>>>
>>>
>>>
>>> ---------------------------------
>>> Be a better friend, newshound, and know-it-all with Yahoo!
>>> Mobile. Try it
>>> now.
>>> _______________________________________________
>>> 200q20v mailing list http://www.audifans.com/mailman/listinfo/
>>> 200q20v
>> _______________________________________________
>> 200q20v mailing list http://www.audifans.com/mailman/listinfo/
>> 200q20v
>
> _______________________________________________
> 200q20v mailing list http://www.audifans.com/mailman/listinfo/
> 200q20v
>
>
>
More information about the 200q20v
mailing list