Car died suddenly, Now won't start

[kneale at knitknacks.com]

You DO  NOT have to pull the tranny to replace the sensor.

You should be able to replace the pin on the engine side of the flywheel
the sensor reads, if that is necessary, through the starter opening in the
engine flange.  

Original Message:
-----------------
From: robert weinberg centaurus3200 at yahoo.com
Date: Sat, 1 Aug 2009 18:33:01 -0700 (PDT)
To: 200q20v at audifans.com
Subject: Re: Car died suddenly, Now won't start


you gotta pull the tranny to replace the sensor? figures. LOL!

as far as the clutch pedal, not sure it's related. sounds like a toasted
clutch master cylinder or slave cylinder. i just had the pleasure of
flipping 034 cash to replace both.

they threw it on the dyno while it was there though. not bad. 034 Stage I
chip. 233 wheel HP, 260 lbs. torque to the wheels. assuming 17% drivetrain
loss, that's about 272HP/305 torque at the crank with just a chip. i do
have samcos, 034 billet bypass and 034 N75H WGFV, but those don't add any
HP.

drove it all day today. when running right, it sure is a pleasure. nearly
ran over 3 hippies in berkeley on our way to Brennan's for BBQ brisket and
irish coffees ;-)

see ya,
Robby




________________________________
From: John Lagnese <jlagnese at massed.net>
To: Mike <xthejuicex at gmail.com>; 200q20v at audifans.com
Sent: Saturday, August 1, 2009 3:29:30 PM
Subject: RE: Car died suddenly, Now won't start

Brace yourself! When that happened to my 91 TQ 20V it was the sensor. It had
broken off from the flywheel. The pins had rusted off. This involved an
expensive sensor, combined with pulling the tranny. This was a $1200 bill
IIRC. I can check if you want. I still feel badly about that. I would have
said goodbye to the car, but I had just had new struts, new tires and a
timing belt done to the tune of $900 about a week before.
Sadly,
John
-----Original Message-----
From: 200q20v-bounces at audifans.com [mailto:200q20v-bounces at audifans.com] On
Behalf Of Mike
Sent: Saturday, August 01, 2009 4:58 PM
To: 200q20v at audifans.com
Subject: Car died suddenly, Now won't start

Hey everyone. I was driving my 200TQ by my house and the engine just died
like if I turned the ignition off. I tried restarting it but it will just
crank and not kick over. Right before it died it did a really weird thing. I
pushed the clutch in and it seemed like it just sank down and wouldn't come
back up easily. It only did that once and the clutch feels normal now and
will spring back up like it should.

I towed it back to my house and checked for any obvious issues. It is
getting fuel as I took off the fuel line by the fuel rail and it will shoot
out fuel when I crank the engine. The distributor still turns so I don't
think the gear broke.

I did the engine blink codes and I got code 2112 which is the Crankshaft
Position Sensor. I was wondering if you all think that this could be the
problem, or if there is a bigger issue. Intended Acceleration site said that
this code could also mean that the Flywheel pin is damaged or missing, How
do I check for this and does this sound like it could be the cause of the
problem?

Any help would be greatly appreciated as I have been trying to get this car
up and running for over 2 months :(

Thanks,

Mike
_______________________________________________
200q20v mailing list    http://www.audifans.com/mailman/listinfo/200q20v

_______________________________________________
200q20v mailing list    http://www.audifans.com/mailman/listinfo/200q20v



      
_______________________________________________
200q20v mailing list	 http://www.audifans.com/mailman/listinfo/200q20v

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.



--------------------------------------------------------------------
mail2web.com – What can On Demand Business Solutions do for you?
http://link.mail2web.com/Business/SharePoint