Brake fittings (conections to front UFO flex hose) frozen,

John Lagnese jlagnese at massed.net
Mon Jan 12 20:46:31 PST 2009


Good luck!!

-----Original Message-----
From: 200q20v-bounces at audifans.com [mailto:200q20v-bounces at audifans.com]
On Behalf Of alancordeiro at att.net
Sent: Monday, January 12, 2009 11:43 PM
To: 200q20v at audifans.com
Subject: Re: Brake fittings (conections to front UFO flex hose) frozen,

Hi guys,

Thanks for all the outpouring of advice. Sorry for the delay in replying
to 
you all....
(I work 37 miles away from home, and got back just in time to have
dinner 
with friends visiting, so this is my first chance to catch up on mail.)

The present brake hose is damaged (outer rubber tearing), I am concerned
it 
is about to give right where it joins the horizontal crimp at the
caliper 
end. I would prefer not to drive my car any distance until I replace the

hose. Consider the hose is fully expendable at this point.

The car has only had one new hose so far ( put on eight months ago, one
of 
the rears was the most marginal)...I ordered a set meaning to replace
all 
one summer afternoon, but when I lost most of the weekend on the first
hose 
replacement, I postponed the other wheels until "later"...and sadly, its

time for the second like RIGHT NOW. I agree that it was way past time to

replace them..........

I had been fairly gentle on the heat, I believe I will attack it with a
lot 
more heat, and if that does not do it, I will go the hard line
replacement 
route. It appears (already studied possibilities while waiting for the 
penetrating oil to work its magic) that I will have to swap the section
from 
the ABS module to the first joint, and at worst, the small section at
the 
caliper as well.  I hope the fittings at the caliper do not behave the
same 
way.
With Michigan temperatures going down to -xx degrees F over the next few

days....I am planning on waiting till this coming weekend

In the meantime, the backup (Olds Intrigue with 145k) will get some
usage.

And sadly, Kneale's comment on his approach reminds me of another
prudent 
replacement item....the timing belt is coming on
75k..........Hmmmm.....is 
that "do the timing belt whenever you do all the hoses"...or the other
way 
around?

Thanks again...

Alan

----- Original Message ----- 
From: "John Lagnese" <jlagnese at massed.net>
To: "'Kent McLean'" <kentmclean at comcast.net>; <200q20v at audifans.com>
Sent: Monday, January 12, 2009 10:13 PM
Subject: RE: Brake fittings (conections to front UFO flex hose) frozen,


> Robbins is usually able to find hard to get parts! One of my favorite
> FLAPS!
> John
>
> -----Original Message-----
> From: 200q20v-bounces at audifans.com
[mailto:200q20v-bounces at audifans.com]
> On Behalf Of Kent McLean
> Sent: Monday, January 12, 2009 12:05 PM
> To: 200q20v at audifans.com
> Subject: Re: Brake fittings (conections to front UFO flex hose)
frozen,
>
> alancordeiro wrote:
>> I spent a frustrating two days waiting for penetrating fluid to do
its
> work,
>> but as of tonight, I have still not succeeded in separating either of
> the
>> two fixed lines from the flexible rubber hose on the driver's front
> wheel.
>
> I had to replace the flex line on my '94 100. It wouldn't
> budge, and so I had to cut the darn hardline. My local FLAPS
> (Robbins in Concord NH) has hard brake lines in both metric
> and SAE? sizes, in 6" increments. I used one that was too
> long and just added a loop to it to make it fit.
>
> Still works fine almost 2 years later.
>
> --
> Kent McLean
> '99 A4, V6 tiptronic
> '91 200 20V Avant, with modes
> _______________________________________________
> 200q20v mailing list
> http://www.audifans.com/mailman/listinfo/200q20v
>
> _______________________________________________
> 200q20v mailing list http://www.audifans.com/mailman/listinfo/200q20v 

_______________________________________________
200q20v mailing list
http://www.audifans.com/mailman/listinfo/200q20v



More information about the 200q20v mailing list