rear window defroster

[robert weinberg]

Thanks Bernie!

Robby




________________________________
From: Bernie Benz <b.benz at charter.net>
To: robert weinberg <centaurus3200 at yahoo.com>
Cc: 200q20V mailing list <200q20v at audifans.com>
Sent: Sun, February 7, 2010 2:23:11 PM
Subject: Re: rear window defroster

You can solder it, BTDT. Tin the window pad with eutectic solder and 44 flux, and the tab also. Then push the tab to the pad and heat with the iron, holding it in place with a pick. Use minimum required heat.

Bernie


On Feb 6, 2010, at 5:53 PM, robert weinberg wrote:

> hi all,
> 
> seems the flat small rectangular conductor that affixes to the rear window for the defroster has separated from the connection point on the rear window. how do you get it back on? seems you can't solder the underside of the connector and if you glue it - how will the two sides make contact? hopefully this makes some semblance of sense.
> 
> Regards,
> Robby
> 
> 
> 
> 
> _______________________________________________
> 200q20v mailing list    http://www.audifans.com/mailman/listinfo/200q20v