2048 crankshaft locking and positioning tool
Kneale Brownson
kneale at coslink.net
Thu Apr 27 06:09:26 PDT 2017
The tool holds the crankshaft so the bolt/belt pullely can be removed.
The timing must be adjusted after belt replacement. The AAN tool will
not work on the 3B. See http://www.quattro123.com/AudiTimingBeltChange.htm
On 4/26/2017 9:52 PM, Randy Mueller wrote:
> The Tool # for Holding the Front Crank Pulley on the 3B engine is 3056
> although the Tool Kneale showed will work fine, as I recall neither Tool
> holds the Crankshaft at TDC
>
> http://www.sjmautotechnik.com/trouble_shooting/Tools/3256tool.jpg
>
> http://www.sjmautotechnik.com/trouble_shooting/S4timing.htm
>
> Later, Randy
>
>
>
> On Tue, Apr 25, 2017 at 3:42 PM, Kneale Brownson <kneale at knitknacks.com>
> wrote:
>
>> Jay, there is an image you may find helpful at
>> http://www.pbase.com/kneale_brownson/image/165349650 If you click the
>> "next" button, you'll get a side view.
>>
>>
>> On 4/25/2017 8:23 AM, Jay Kempf wrote:
>>
>>> Understood and I do but I am under the understanding that this is the
>>> crankshaft positioning tool for holding the thing in position during the
>>> entire TB job so I thought I should build one. The reason I want to have
>>> the dimensions of the original is so I can modify it to clip on somewhere
>>> else. Having the original allows me to work from that to get to somewhere
>>> else.
>>>
>>> regards,
>>>
>>> jfk
>>>
>>> 802 272 5868
>>>
>>>
>>> On 4/25/2017 10:20 AM, Bernie Benz wrote:
>>>
>>>> Not needed if you have a good impact wrench.
>>>> Bernie
>>>>
>>>> On Apr 25, 2017, at 7:01 AM, Jay Kempf wrote:
>>>>
>>>> I am looking at making a crankshaft locking tool (3B). I got close to
>>>>> the dimensions just based on some published stuff and have built a 3D
>>>>> model. I have a plasma cutter and welder and materials to make the thing
>>>>> but don't have the dimensions and clocking of the slot. Does anyone have
>>>>> one I could get them to take some measurements or to put it on a scanner to
>>>>> get the clocking of the slot? It would fit on a 8.5 x 11 all in one printer.
>>>>>
>>>>> --
>>>>>
>>>>>
>>>>> regards,
>>>>>
>>>>> jfk
>>>>>
>>>>> 802 272 5868
>>>>>
>>>>>
>>>>>
>>>>> _______________________________________________
>>>>> 200q20v mailing list http://www.audifans.com/mailman/listinfo/200q20v
>>>>>
>>>>
>>> _______________________________________________
>>> 200q20v mailing list http://www.audifans.com/mailman/listinfo/200q20v
>>>
>> _______________________________________________
>> 200q20v mailing list http://www.audifans.com/mailman/listinfo/200q20v
>>
> _______________________________________________
> 200q20v mailing list http://www.audifans.com/mailman/listinfo/200q20v
More information about the 200q20v
mailing list