[A4] o2 sensor

[Richard Hurt]

What's the process for a 2.8 30v?

Later...
  Richard



Brizax at aol.com wrote:

> its a pretty basic repair, its just a tight squeeze, youd need to 
> remove the air box "air filter and maf, then look down on the large 
> oval exaust pipe coming off the turbo, one sensor is up high one is on 
> the bottom right  "assuming you guys have 1.8t's" youll need a good 
> wrench, dont try and use an adjustable, i think its a 17mm but might 
> be wrong, if you go to pep boys or advanced auto etc they can scan 
> codes for free and tell you if its the pre or post cat o2 sensor, GL :)



This communication is confidential and may be legally privileged.  If you are not the intended recipient, (i) please do not read or disclose to others, (ii) please notify the sender by reply mail, and (iii) please delete this communication from your system.  Failure to follow this process may be unlawful.  Thank you for your cooperation.