[ba] looking for early 80's exhaust system

[Dan Hamren]

I just had 2 new cats, a Flowmaster, and a tip custom built for my Range
Rover for $450.00.  I could have gone with a 3" system, but to keep the
cost down he re used some of the original piping which was in good
shape, and since the exhaust manifolds are not any bigger it didn't make
sense to open the system up when it would still be restricted up near
the engine.  PS the he quoted me $550.00 for the complete 3 inch with 2
new cats and a tip.
All American Muffler on Middlefield in Redwood City ask for Jose.

Dan Hamren 


-----Original Message-----
From: ba-group-bounces at www.audifans.com
[mailto:ba-group-bounces at www.audifans.com] On Behalf Of Ti Kan
Sent: Sunday, May 30, 2004 11:43 AM
To: audion at serversmiths.com
Cc: Bay Group
Subject: Re: [ba] looking for early 80's exhaust system

audion at serversmiths.com writes:
> I'm looking for a cat and a cat-back exhaust system for my 82 Coupe. 
> Thought I'd post to see if any list members have something hanging 
> around in the garage or perhaps a lead on a source.
> 
> Since the car is 22 years old I'd prefer to find something used but 
> would welcome tips/advice on new systems too.

If you're looking for a canned aftermarket "kit", there wasn't any.
However any competent muffler shop should be able to make you
a custom one by fabbing the pipes and installing the mufflers
of your choice.  You can replace your stock cat with a higher
flow version offered by Techtonics.  Just look for the high flow
unit designed for the early VW Rabbit/Scirocco cars.
	http://www.techtonicstuning.com

-Ti
-- 
 R 1 3 5  Ti Kan
 |_|_|_|  http://www.amb.org/ti
   | | |  Vorsprung durch Technik
   2 4 6
_______________________________________________
Audifans ba-group mailing list
Send posts to: mailto:ba-group at www.audifans.com
Manage your list connection:
http://www.audifans.com/mailman/listinfo/ba-group
Have an Audi question?  Check the Audifans Knowledgebase!
http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/WebHome
Have an Audi answer? ... Please help others by adding to the KB ... all
contributions welcome!