[Biturbos4] Alternative Boost Gauge Tap-in Location

[Keman]

I used the line that goes to the diverter valves. Whenever one of the valves 
blew- I knew instantly because at idle the vacuum was barely present.

- Keman

----- Original Message ----- 
From: "Quincy Chiang" <b5quattro at shaw.ca>
To: <biturbos4 at audifans.com>
Sent: Saturday, July 09, 2005 3:26 PM
Subject: [Biturbos4] Alternative Boost Gauge Tap-in Location


: Hi everyone,
:
: I need to replace the vacuum line on my AWE boost gauge, and I want to 
change the tap in location from the fuel pressure regulator to the intake 
manifold pressure.  This is because a leak at the existing tap in point can 
cause the car to run lean, not a good thing at all.  So my question is where 
is the intake manifold pressure line?  Thanks for any help!!
:
: Quincy
: '01.5 S4
: '90 CoupeQ