[Biturbos4] where to plumb for boost gauge ?

[Quincy Chiang]

I have a AWE vent boost gauge, it's awesome.  I connected the hose to the fuel pressure regulator as described in AWE's installation guide, so far so good, except I noticed a crack on the outside of the hose last week at the driving school.  When I mentioned this to the chief instructor Keith Anderson (long time ACNA instructor and VP), he said I really should relocate the tap-in point, because a leak there can case the car to run lean, that's very very bad.  I'm aware of that but that location just seems so convineient.  Once I have some time I'll buy a braided rubber hose I'll look into relocating the tap-in point so the manifold pressure sensing line, which is the proper way to connect a boost gauge.  I did that on my ex-A4, just need to figure out where it is in the S4.

Quincy

----- Original Message -----
From: Erik De Bonte <Erikd at lith.com>
Date: Monday, May 23, 2005 11:13 am
Subject: RE: [Biturbos4] where to plumb for boost gauge ?

> I have the AWE vent guage.  The installation guide
> (http://www.awe-tuning.com/media/pdf/ventgauge.pdf) shows where it 
> getstied in.  See step 10.
> 
> -Erik 
> 
> -----Original Message-----
> From: biturbos4-bounces at www.audifans.com
> [biturbos4-bounces at www.audifans.com] On Behalf Of Thomas Pollock
> Sent: Monday, May 23, 2005 10:03 AM
> To: biturbos4 at audifans.com
> Subject: [Biturbos4] where to plumb for boost gauge ?
> 
> Hi all...
> 
> hey where are you guys plumbing in for your boost gauges ?
> 
> thanks,
> 
> tom.
> 
>        	
> ---------------------------------
> Do you Yahoo!?
> Yahoo! Mail - Helps protect you from nasty viruses.
> _______________________________________________
> Biturbos4 mailing list
> Biturbos4 at www.audifans.com
> http://www.audifans.com/mailman/listinfo/biturbos4
> _______________________________________________
> Biturbos4 mailing list
> Biturbos4 at www.audifans.com
> http://www.audifans.com/mailman/listinfo/biturbos4
>