[Biturbos4] Detecting "limp" mode?

[Chris Newbold]

On Sat, Mar 15, 2008 at 10:14 PM, Joel Liggins <quickaudi at gmail.com> wrote:

> Log blocks 92 and 93 and tell me what your CFs are for the cam position
> sensors.

On block 93, the CF for bank 1 is consistently 0, and bank 2 is pegged
at -7. Looks like there's something up in bank 2.

Block 92 shows "cam control" always off, and the CF adjustment wavers
between 0 and -1. This was a grocery run, so I didn't get any WOT
action or RPM > 4000, so the data may be limited in that regard.

Looking in Bentley, it seems like the place to start is to pull the
bank 2 hall sender and see if the rotor has been positioned on the
camshaft correctly. That looks straight-forward enough.

What are your thoughts?

-Chris
2001.5 S4 Avant 6spd