[e//S2] Using S2 engine harness

Ben Klumper bklumper at mdbworld.com
Thu Sep 11 18:17:23 EDT 2003


Joe,

As i've been learning in the last few weeks, adapting the 3B harness from
the 200 is actuall not as difficult as it first seems. In fact, there are
really only about 25 steps to fully integrating it (which i will publish as
soon as i can get my notes organized!). an S2 harness is extremely hard to
find (i've tried) and can be quite expensive as well. by the way, i also
looked into a new one but it was about $1700. but if you can find a used
one, i'm sure it would make things a little easier (still some coordination
req. with the rest of the coupe's wiring), although getting ahold of the
schematics might be tough.

ben

----- Original Message -----
From: "Joseph W. Marconi III" <jwmarconiiii at sbcglobal.net>
To: <es2 at audifans.com>
Sent: Thursday, September 11, 2003 11:18 AM
Subject: [e//S2] Using S2 engine harness


> Hi all.  Has anyone considered looking into the possibility of buying a S2
> engine harness from a European wrecker.
> Would it not be easier to install a '91 200tq 3B engine with a 3B powered
S2
> harness than adapt the '91 200tq harness to the  '90 -'91Coupe 20v 7A
powerd
> car???
>
> Opinions please or BTDTs welcome
>
> THanks in advance
>
> Joe Marconi   Toledo, Ohio
>
> '90 CQ
> '91 200 TQ
> '93 90 CSQS
>
> _______________________________________________
> eS2 mailing list
> eS2 at audifans.com
> http://www.audifans.com/mailman/listinfo/es2




More information about the Es2 mailing list