[Es2] It's Alive!

[Jimmy Pribble]

> Great news Jimmy! I knew it wouldn't take long!

Thanks, Ben!

> Sounds to me like you have the wires on the two-prong oil pressure sender
reversed. Of course, I'm sure that's the first thing you checked!

Actually, by that hour, I just cleaned-up the garage, posted-up my success,
and went to bed; so, I didn't check anything.  My (bad) memory is
remembering the oil pressure sender as having just a single wire screwed
into an eyelet connector at the sender and going all the way back to the
gauge.  Am I mis-remembering?

> Also make sure you have an RPM signal going to T26b/23 - that's where my
fault was. Good luck!

I'm almost certain that I will find this is my problem as well.  Thanks
again!

Jimmy