[Es2] Compatibility of URS4 clutch and flywheel

[Ben Klumper]

I'm using all stock CQ clutch parts and have had no slippage issues, but I'm 
only at about 275 hp.

Ben

----- Original Message ----- 
From: "Brandon Hull" <Hull at cardinalpartners.com>
To: <Elijahallen92 at aol.com>; <es2 at audifans.com>
Sent: Friday, March 04, 2005 11:22 AM
Subject: RE: [Es2] Compatibility of URS4 clutch and flywheel


I believe the flywheel for the AAN is a dual mass design that makes for
a thicker assembly than the 7A.  I believe almost everyone has used the
CQ flywheel and various clutch solutions.  In my case, I have the CQ
flywheel which was lightened 5-6lbs, the CQ pressure plate and an RS2
clutch disk.  (trans is RS2 six speed)  This has been fine for 35K
miles.
I still have an RS2 flywheel and pressure plate if anyone wanted to buy
it.

Brandon

> -----Original Message-----
> From: es2-bounces at audifans.com
> [mailto:es2-bounces at audifans.com] On Behalf Of Elijahallen92 at aol.com
> Sent: Thursday, March 03, 2005 8:25 AM
> To: es2 at audifans.com
> Subject: [Es2] Compatibility of URS4 clutch and flywheel
>
>
> Hey guys, does the stock Coupe 5 speed mate up to the urs4
> clutch and
> flywheel or does there need to be changes made? Thanks,
>
> Elijah
> _______________________________________________
> Es2 mailing list
> Es2 at audifans.com
> http://www.audifans.com/mailman/listinfo/es2
>
>

_______________________________________________
Es2 mailing list
Es2 at audifans.com
http://www.audifans.com/mailman/listinfo/es2