air metering valve tension

Ti Kan ti at amb.org
Mon Aug 21 22:29:36 EDT 2000


JShadzi at aol.com writes:
> In a message dated 8/21/00 8:53:11 PM Pacific Daylight Time, 
> rdmiller at nwinternet.com writes:
> << hello all,
>  
>  How much tension should the air metering valve have? 
>  
>  Richard Miller
>   >>
> 
>     It should move freely up and down thru its travel- the weight of the air 
> plate assy. itself should should be the only factor resisting lifting.
> Javad

I assume the question refers to the K-Jetronic (CIS) and the KE-Jetronic
(CIS-E) systems with the round air flow sensor plate and attached
fuel distributor.  In addition to the plate's and arm's mass, there is
also some additional resistance imposed by the control fuel pressure on top
of the plunger within the fuel distributor.  If the engine was recently run
and the fuel system is still pressurized, it is normal to encounter some
resistance if one is to pull up on the plate manually.

-Ti
01 S4 2.7 biturbo (coming)
96 A4 2.8 quattro
84 5000S 2.1 turbo
80 4000 2.0
-- 
    ///  Ti Kan                Vorsprung durch Technik
   ///   AMB Research Laboratories, Sunnyvale, CA. USA
  ///    ti at amb.org
 //////  http://metalab.unc.edu/tkan/
///





More information about the quattro mailing list