G60 Conversion on `89 90 Quattro
Mark L. Chang
mchang at ee.washington.edu
Sun Aug 27 21:39:23 EDT 2000
On Sat, 26 Aug 2000, Todd Phenneger wrote:
> I do believe that the A4 uses a slightly different diameter rotor than
> the 90q and 5kt. I think it is about 28?mm. However, I suspect it
> would be better than the G-60 if you could get it to fit. Lighter
> (more like the G-54) but a better caliper than G-54.
My bad--it wasn't Ti Kan (although he still is one helpful dude), it was
Eric Fluhr--that measured the A4q rotor to be 288mm. Again, it was in his
hands, so I don't doubt the measurements.
As far as G60s vs. A4q caliper, I am going to say that the A4 calipers are
the way to go, if one can find them cheaply. The only problem then becomes
the 288mm vs. 276mm rotor size with the unusual 90q20v deep-hat
design. We'll see. Anyone else got ideas besides a 2-piece Coleman rotor?
> Does ANYONE have some old 944t pads laying around so I can get
> these 944t Calipers setup to mount to the struts in question. I'm not
> sure what I'll do if I'm successful but I will make the results
> available.
Not me! :P
--
Don't worry if you're a kleptomaniac, you can always take something for it.
- Unknown
More information about the quattro
mailing list