Heebie Jeebies

[mike]

 > we had a block with steel caps, due to oil surge a
> > shell picked up on the crank and rotated in the
> cap.
> 
> > we just milled a mm off the end of the cap and
> then
> > had the whole thing line bored at a local
> engineering
> > works
> 
> There aren't any shells in I5 cam bearings - the cam
> runs in the
> machined head.

Phil... it's not a shells thing.. point i was making
was if you machine a bit off the base of a cap the
hole gets smaller and you can then get it linebored
back to standard.

Mike

__________________________________________________
Do You Yahoo!?