Seats - 200Q/5000TQ - Memory No Worky

[Swann, Benjamin R. (BSWANN)]

Nah, the memory was working just fine until I swapped the seats.

Ben
-----Original Message-----
From: Peter Berrevoets
To: 'Swann, Benjamin R.  (BSWANN)'; 1 Quattro List (E-mail)
Sent: 11/29/00 9:45 PM
Subject: RE: Seats - 200Q/5000TQ - Memory No Worky

I had this problem with the original seats in my 1990 200TQ - the
problem
ended up being the control buttons on the door. Replacing that
combination
switch restored the function to the seat memory.

Seems the previous owner left the window open and it got a little too
wet!

HTH

Peter Berrevoets
1990 200TQ
Toronto, Canada

> >
> >I recently installed  Seats from a '90 200 Q into the '87 5000TQW.
> >
> >I had to change the power connector,  that works fine.
> >Except for the power
> >connector which used 2 - 10 Guage into 1 - 8 guage for both
> >positive+ and
> >Ground-, instead of the 4 -12gu into 2 - 10 gu into 1 8
> >guage in the '87,
> >all other conectors plugged in one for one.
> >
> >After I got them installed, I have not been able to save/use the seat
> >position memory feature.  All adjuster work fine.  Just
> >can't store the
> >position setting for recall.
> >
> >The heaters workd fine, and the position servo's operate as
> >expected.  I am
> >just missing the memory portion.
> >
> >Any ideas?  Is the memory controller different in these
> >seats, or do I just
> >have a bad unit that I can swap out from the original seats.
> >
> >Ben Swann
> >'87 5KCSTQW with 200Q seats.
> >
> >