91 Audi 200 center taillight section

[Thomas J. Donohue, Jr.]

Zoran & Mike...thanks for the info.  Should have known that there would
be nuts from the inside, but Bentley doesn't happen to mention them...at
least not at 66.5 "Rear license plate panel, removing".  However, now I
have another problem.  When I tried to fit the new panel, it wouldn't.
It carries part #477-945-695-D and has sort of a wing-shaped waffled
black plastic section above the actual lenses themselves, which makes
the assembly approximately 8" high at the ends; the broken assembly that
I took out doesn't have the black "wing" at all, measures about 7-3/8"
high and carries part
#477-945-695-P.  It won't fit into the wagon's sheet metal.  Anyone have
any suggestions, other than trying to find another lens panel?  Thanks.
Tom Donohue

Zoran Hranisavljevic wrote:

>  Hi Tom!First make sure you disconnect those 4 8mm nuts (2 on each
> side), at the mounting bracket(s). After that, it is only pry out
> fight with the existing sealer.Zoran
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.audifans.com/pipermail/quattro/attachments/20000909/1f11e5f3/attachment.htm